Actions
Bug #1005
closedUnable to read radio?????
Status:
Closed
Priority:
Normal
Assignee:
-
Category:
-
Target version:
-
Start date:
07/19/2013
Due date:
% Done:
0%
Estimated time:
Chirp Version:
daily
Model affected:
FT-7900R
Platform:
Windows
I read the instructions above:
Description
I have a Yeasu ft-7900 R. I have the radio set to F-& clone mode in display. I am using model selection from drop down menu of 7800 as
7900 is not listed. Per you instructions after hitting ok i press the vm/mw key on radio thats supposed to put it in YX mode but nothing happens and I get the following error message *Failed to communicate with radio: Failed to read header (0)
Any suggestions ????
Updated by Tom Hayward over 10 years ago
- Status changed from New to Feedback
If you still have "F-7 CLONE" on the display, you've missed a few steps. From page 66 of your FT-7900 manual:
- Rotate the DIAL knob on each radio to select (F-7 CLONE), then press and hold in the @[BAND(SET)]@ key. The display will disappear for a moment, then the "CLONE" notation will appear on the display.
- Now, on the "Source" radio, press the @[V/M(MW)]@ key. The "- - TX - -" indicator will appear on the display, and the cloning data transfer will immediately begin.
Updated by Bernhard Hailer about 4 years ago
- Status changed from Feedback to Closed
- Chirp Version changed from 0.3.0 to daily
No more feedback by submitter.
Actions