https://chirpmyradio.com/https://chirpmyradio.com/favicon.ico?16699092072017-02-09T05:09:30ZCHIRPCHIRP - Bug #4473: Puxing PX-2R Nameshttps://chirpmyradio.com/issues/4473?journal_id=126612017-02-09T05:09:30ZRichard Perlman
<ul></ul><p>I have finally been able to get the Puxing software to run and compare it to chirp. First, the regular PX-2R software would not work with my radio. I needed to find the PX-2R-Plus software. While my radio says it is a PX-2R, the box says it is a Plus, and that is, it seems, the case. Note my radio has PX-2R on the case and inside the radio it is marked as Model:PX-2R U/v (tx/rx UHF, rx VHF).</p>
<p>When I read from the radio using the Puxing software it did indeed read blanks from the first 10 memory locations locations. However, when I entered values for those names it was able to write them out. I was then able to read the name values into chirp. But, it can't write out changes.</p>
<p>I also found a serious bug in the Puxing. The tx and rx frequencies are reversed in the PC & Chirp interface. In the Puxing software, you just write the tx freq in the rx column, and vice-versa. In chirp you need to enter the tx freq in the frequency column and then enter a backwards offset (I.e. a +5mHz offset is entered as -5mHz).</p>
<p>And, finally, although the radio can be set to receive VHF (through the radio interface) neither chirp nor the Puxing software will allow these frequencies to be set.</p>
<p>YMMV</p>
CHIRP - Bug #4473: Puxing PX-2R Nameshttps://chirpmyradio.com/issues/4473?journal_id=224272020-04-19T05:41:02ZBernhard Hailerae6yn@arrl.net
<ul><li><strong>Subject</strong> changed from <i>Puxinf PX-2R Names</i> to <i>Puxing PX-2R Names</i></li><li><strong>Target version</strong> set to <i>chirp-legacy</i></li><li><strong>Model affected</strong> changed from <i>PX-2R</i> to <i>Puxing PX-2R</i></li></ul>