Feature #10719
closedDisabling TX on UV-K5 with modded firmware.
0%
Description
Is there a way to add the ability to disable transmitting on certain freqs? I'm using the modded firmware and would like to listen to the CHP but I can't seem to find a way to turn off TX. I don't want to TX by mistake.
Thank
AMC
Updated by Dan Smith over 1 year ago
- Is duplicate of Bug #10702: Quanshen UV-K5 - cannot disable TX on a channel - no OFF selection under Duplex added
Updated by Dan Smith over 1 year ago
- Assignee set to Jacek Lipkowski SQ5BPF
- Target version set to chirp-py3
Are you running the latest? This was (AFAIK) fixed a couple days ago in #10702.
Updated by Jacek Lipkowski SQ5BPF over 1 year ago
See if the latest chirp-next will disable TX for you.
There is no TX disable in this radio. I'm faking it by setting a negative offset equal to the rx frequency, which results in tx at 0MHz.
It does work on stock firmware, however in the hacked firmware the function that disables/enables TX is often patched to always allow.
I can't check on a real radio right now, but if it enables TX, then i will change he offset to tx in the middle of the 640-850MHz range tat is not supported by the BK4819 chip
VY 73
Jacek / SQ5BPF
Updated by Wito Krasnal over 1 year ago
the faking works. it disables Tx, a "blip" sounds and "DISABLE" is shown on LCD like on AM channels
Updated by Jacek Lipkowski SQ5BPF over 1 year ago
- Status changed from New to Closed