Project

General

Profile

Actions

Bug #2187

closed

TYT TH-9800

Added by Richard Everett almost 10 years ago. Updated over 9 years ago.

Status:
Closed
Priority:
Normal
Assignee:
Category:
-
Target version:
-
Start date:
01/11/2015
Due date:
% Done:

100%

Estimated time:
Chirp Version:
0.4.0
Model affected:
TH-9800
Platform:
All
Debug Log:
I read the instructions above:

Description

1/ When double clicking on a channel's frequency field in the main channel table view (to enter a new frequency), an 'illegal frequency' (or similar) message box appears as the default value is set to '000.0000'. You cannot access the frequency feild until this error box is closed. i.e Double clicking on the frequency field should highlight the feild and allow you to enter a new/valid frequency regardless of what is in this box. The illegal frequency message should only be displayed if an invalid frequency is entered.

2/ Despite entering NFM into the mode field, it is not actually written into that memory entry when writing to the radio. I have confirmed that the TYT software does set this field correctly.

3/ The TH-9800 allows three receiver IF filter bandwidths (Wide, Mid & Narrow) for all receive modes including AM. There is no provision within Chirp to adjust these. There is provision to adjust TX deviation though.
AM voice reception is actually best with the Mid setting, rather than the default Wide setting.

Actions

Also available in: Atom PDF