Project

General

Profile

Actions

Bug #4339

open

Yaesu FT-8900 repeater offset

Added by Bob Mueller almost 8 years ago. Updated over 4 years ago.

Status:
New
Priority:
Normal
Assignee:
-
Category:
-
Target version:
Start date:
12/28/2016
Due date:
% Done:

0%

Estimated time:
Chirp Version:
daily
Model affected:
Yaesu FT-8900
Platform:
Windows
Debug Log:
I read the instructions above:

Description

https://www.repeaterbook.com/repeaters/details.php?state_id=39&ID=450

the repeater above has an offset of 0.24. If I type that offset into CHIRP, it initially seems to take the offset. However, it does not take that offset. When I save the programming file (IMG), and then re-open the file, the offset is changed to 0.2. If I try to program the radio, CHIRP changes the offset to 0.2. If I try to import a CSV file with the correct 0.24 offset, that is changed to 0.2. CHIRP will not take the 0.24 offset required for this repeater.

Actions #1

Updated by Bob Mueller almost 8 years ago

I was able to get the repeater programmed using "split"

I still think this is a bug, as CHIRP allows to enter an offset value that you can not save or program to the radio.

Actions #2

Updated by Bernhard Hailer over 4 years ago

  • Assignee deleted (Bob Mueller)
  • Target version set to chirp-legacy
  • Model affected changed from (All models) to Yaesu FT-8900

Have you tried with a recent version since you submitted this? I'm asking because there might have been some changes in the driver since you tried last.

Actions

Also available in: Atom PDF