Actions
New Model #7555
closedCannot clone FT-450 (NON-D model)
Start date:
01/13/2020
Due date:
% Done:
0%
Estimated time:
Equipment Loan/Gift Offered:
No
I read the instructions above:
Description
Get error message "Failed to communicate with radio: Unable to read block 0 expected 6 got 4" no matter what the radio's cat setting are set to. Also noted in the FT-450D manual that you cannot clone between a 450 and a 450D, so I assume they are different. Only the 450D shows up in the list, please add support for the 450.
Files
Updated by Bernhard Hailer almost 5 years ago
- Status changed from New to Closed
- Target version set to chirp-legacy
Request already made, see #7135.
Updated by Bernhard Hailer almost 4 years ago
There is a possible solution (a firmware upgrade) suggested in #7839; please check and see whether it helps.
Updated by William Curlew almost 4 years ago
The last firmware for the FT450 NON-D version was V0228. You cannot load the 450D version V-244 firmware into the non-D radio without bricking it.
Bill Curlew
Updated by Bernhard Hailer almost 4 years ago
Thanks for the clarification. A similar comment was made on #7135, where this discussion should continue.
Actions