Project

General

Profile

Actions

Bug #169

open

VX-7 doesn't recognize memory groups until one is set on the radio's keypad

Added by David Griffith over 12 years ago. Updated about 3 years ago.

Status:
Feedback
Priority:
Normal
Assignee:
-
Category:
-
Target version:
Start date:
05/11/2012
Due date:
% Done:

0%

Estimated time:
Chirp Version:
daily
Model affected:
Yaesu VX-7R
Platform:
All
Debug Log:
I read the instructions above:

Description

If you create a setup for the Yaesu VX-7 which has frequencies assigned to memory groups, the VX-7 will not recognize any of them as being valid unless and until you assign a memory slot to a memory group from the radio's keypad. After this is done, all memory slots are assigned to memory groups as they appeared in Chirp in addition to the assignment you just made.

Here are two image files containing three memories assigned to memory group 1 and are identical except that test1.img is buggy in this regard whereas test2.img is not.


Files

test1.img (15.8 KB) test1.img buggy David Griffith, 05/11/2012 10:05 PM
test2.img (15.8 KB) test2.img good David Griffith, 05/11/2012 10:05 PM
test.diff (3.98 KB) test.diff Diff of test2.img against test1.img David Griffith, 11/16/2015 09:41 PM
mg-test1.hex (66.3 KB) mg-test1.hex another test, but with just one channel set David Griffith, 11/16/2015 09:47 PM
mg-test2.hex (66.3 KB) mg-test2.hex one channel, after being uploaded, manually set a MG, then downloaded again David Griffith, 11/16/2015 09:47 PM
mg-test.diff (4.65 KB) mg-test.diff Diff of mg-test1.hex against mg-test2.hex David Griffith, 11/16/2015 09:47 PM
Actions

Also available in: Atom PDF