Bug #3791
openTYT TH9000D 220 MHZ Mono Band
0%
Description
CHIRP Daily 20160702, also in older versions.
After successfully reading the radio:
DTCS for TX is Correct
DTCS for RX reads 023N vs Programmed 065N (written by TYT Software Version 1.0.8)
"CrossMode" DTCS becomes Tone->Tone, should be DTCS.
Subsequent Read/Write of Radio to/From TYT Software was verified correct with a handheld TX.
Changing the 023N in CHIRP to 065N and crossmode to ->DTCS then writing to the radio, reading from TYT it is correct.
It seams to be a GUI Display issue with CHIRP for this Model.
The GUI Display also appends subsequent characters behind channel label blocks that are not used, as in short names.
This bug was basically accidently stumbled upon
Thank You,
Rich Davis W4NMH EMT
ARRL Life Member, Instructor
Official Emergency Station (OES)
Official Relay Station (ORS)
Technical Specialist (TS)
Volunteer Examiner (VE)
(removed irrelevant text [AE6YN])
Files
Updated by Rich Davis over 8 years ago
Also, for CTCSS and/or DCS Receive to work properly you have to edit to set Squelch per channel from Carrier Operated to "CTCSS/DCS Operated."
I do not see how to do that in CHIRP just in the HYT Software.
Thank You,
Rich W4NMH
Updated by Bernhard Hailer over 4 years ago
- Description updated (diff)
- Model affected changed from (All models) to TYT TH-9000D (220)