CHIRP

Unsure how to check to see if it has a Prolific chip. Assuming it didn't I follow the instructions on downgrading the driver device yesterday. It gets about 1/2 and just pauses. After letting it pause for a hour or so. I unplugged the cable, looked at the radio and the programmed frequency's and names were in the there without the clone finishing.

Step 11 in the link above shows you how to find the Driver tab in Device Manager which shows you the chip vendor and installed driver version.

Jim KC9HI

Confirm that you have a Prolific chip and if you do confirm that you have the v3.2.0.0 device driver installed. If confirmed and the failed upload still happens, then attach a debug log of the failed upload.

Jim

After looking at step 11 on the site, it is a prolific. In the driver tap is says its driver version 3.8.3.0. I did have to change the driver to v3.2.0.0 to read on chip, and that's what I was using when the clone pauses.

Start CHIRP, do an upload that fails, close CHIRP and attach the debug.log here.

Detail for locating the debug.log file are on the "How to report issues":http://chirp.danplanet.com/projects/chirp/wiki/How_to_report_issues page.

Jim

I added debug.log file in the issue page

Where is it?

Jim

http://chirp.danplanet.com/issues/4649