Bug #6199
closedBaofeng UV-6R
0%
Description
1.Bug: Die Welcome Message habe ich abgeändert in Line 1: Hi , Line2: Peter . Nach erfolgten Upload zum Funkgerät habe ich wieder downgeloaded um zu überprüfen ob die Settings übernommen
wurden. Das war nicht der Fall. Es stand wieder Welcome in Line 1 und nicht Hi in Line 1 und Peter
in Line 2.
2.Bug: Unter Service Settings habe ich die Squelch Level abgeändert, da die Vorgaben zu empfindlich und zu eng gestaffelt waren. Nach erfolgten Upload zum Funkgerät habe ich wieder downgeloaded um zu überprüfen ob die Settings übernommen wurden.
Das war wieder nicht der Fall. Es standen wieder die alten Squelch Level unter Service Settings drin. Beim Baofeng GT-3TP kann ich mühelos mit dem Chirp Pprogramm die Welcome Message und die Squelch Level abändern. Bitte danach schauen. Beim GT-3TP gehts ja auch.
Files
Related issues
Updated by Bernhard Hailer over 4 years ago
- % Done changed from 100 to 0
- Estimated time changed from 1.00 h to 0.00 h
Hallo Peter,
Du solltest Anfragen hier auf Englisch abfassen, sonst wirst Du moeglicherweise weniger Glueck mit Antworten haben.
Ich hab's mal uebersetzt, hoffentlich hilft's.
73
Bernhard AE6YN, DL4MHK
1st bug: I changed the Welcome Message to Line 1: Hi, Line2: Peter. After uploading to the radio, I downloaded again to check whether the settings were accepted. That was not the case. It was again Welcome in Line 1 and not Hi in Line 1 and Peter in line 2.
2nd bug: I changed the squelch level under Service Settings because the original settings were too sensitive and spaced too narrowly. After uploading to the radio, I downloaded again to check whether the settings were applied. That was again not the case.
The old squelch levels were again under Service Settings. With the Baofeng GT-3TP I can easily change the welcome message and the squelch level with the Chirp program. Please have a look. The GT-3TP also works.
Updated by Jim Unroe over 4 years ago
- Status changed from New to Feedback
Hi Peter,
Unfortunately this is due to a change in the radio, not a CHIRP bug. The "welcome message" and "squelch threshold" settings require access to the "aux memory" area of the radio. The early radio models supported this, therefor these settings were added. The newer radios no longer provide CHIRP access to the "aux memory" area so these settings cannot be updated.
Jim KC9HI
Updated by Bernhard Hailer about 4 years ago
- Status changed from Feedback to Closed
Ticket closed; duplicates #6369.