Project

General

Profile

Actions

Bug #2989

closed

AT-5888UV Squelch Mode Setting

Added by Russell Vernon almost 9 years ago. Updated almost 4 years ago.

Status:
Closed
Priority:
Normal
Assignee:
-
Category:
-
Target version:
-
Start date:
11/09/2015
Due date:
% Done:

0%

Estimated time:
Chirp Version:
daily
Model affected:
Anytone AT-5888UV
Platform:
Windows
Debug Log:
I read the instructions above:

Description

It seems that the Squelch Mode on my Any Tone AT-5888UV is stored on a channel-by-channel basis in memory. If I use the stock software for the radio, there is an option to set the 'Carrier Mode' to either 'Carrier', 'CTCSS/DCS', 'Option Signaling', 'CTCSS/DCS And Option Signaling', 'CTCSS/DCS Or Option Signaling'. I can find no where to set it to canvas all memories. In CHIRP, there is no where to set this feature, and thus when I use CHIRP to program a new channel, it will disregard any decode on the RX. and use only carrier squelch. CHIRP will set the TX encode, to key up repeaters. But the decode fails unless you either go into the stock software, or manually set the option for that memory location on the radio itself. I am using the CHIRP daily-20151023 build.


Related issues 1 (0 open1 closed)

Related to Feature #6633: CTCSS squelch on Anytone 5888Closed03/22/2019

Actions
Actions #1

Updated by Bernhard Hailer over 4 years ago

  • Status changed from New to Feedback
  • Model affected changed from AT-5888UV to Anytone AT-5888UV

Is this still an issue?

Actions #2

Updated by Brad Schuler almost 4 years ago

Related to issue #1491

Actions #3

Updated by Bernhard Hailer almost 4 years ago

  • Status changed from Feedback to Closed

See #1491.

Actions

Also available in: Atom PDF