Bug #6893
closed
Added by Conrad Smith almost 5 years ago.
Updated over 3 years ago.
Model affected:
Baofeng UV-5RTP
I read the instructions above:
Description
When I try enter a PMR frequency ie 446.153125 MHz in properties it changes to 446.1530120 MHz after I click ok and when I check the memories list. If I open properties again for that channel is appears as 446.153120 MHz. It is same issue with all frequencies with a 0.000005 MHz value. Can't seem to save any 0.000005MHz value.
- Status changed from New to Feedback
- Assignee deleted (
Conrad Smith)
- Model affected changed from uv5rtp to Baofeng UV-5RTP
Can you set the channel steps to 12.5 kHz?
- Status changed from Feedback to Closed
- Platform changed from Windows to All
Conrad Smith wrote:
When I try enter a PMR frequency ie 446.153125 MHz in properties it changes to 446.1530120 MHz after I click ok and when I check the memories list. If I open properties again for that channel is appears as 446.153120 MHz. It is same issue with all frequencies with a 0.000005 MHz value. Can't seem to save any 0.000005MHz value.
1 The frequencies listed are for dPMR (digital PMR). This radio is analog only.
2 This radio does not support the dPMR frequency spacing. It only supports frequencies with the following resolution.
XXX.XXX00 MHz
XXX.XXX25 MHz
XXX.XXX50 MHz
XXX.XXX75 MHz
CHIRP cannot make a radio do anything it is not capable of doing. Sorry.
Note: The analog PMR446 frequencies are included in the "EU LPD and PMR Channels" stock config file.
Jim KC9HI
Also available in: Atom
PDF